P8 PWM
Pressure-optimised 80 mm Fan with PWMVerfügbarkeit: Ausverkauft
Optimised for Static Pressure
During the development of the new P8 PWM, special emphasis was placed on a focused airstream and thus a high static pressure. The fan guarantees extremely efficient cooling, even with increased air resistance. Therefore, the P8 PWM is particularly suitable for use on heatsinks and radiators.
Strong Cooling Performance
Numerous improvements, such as an updated engine technology and a newly developed fan design, have noticeably increased the performance of P-fans.
In internal performance tests leveled to 28 dB (A), the new P-fans left many competitors behind. More information can be found in our FAQ.
Thermal Resistance in Push-mode on Freezer 34 Heatsink @ 28dB(A) in 50 cm
P8-Series
Noctua A12x25
Noctua NF-P12 PWM
Thermaltake TT-1225
Enermax VCTBP12-C
<<< Better
* tested with Prime 95, CPU Power Package 95 W (i7-8700K)
More Efficient Technology
The motor is powered by a Neodym-Iron-Boron-Magnet ring of the newest generation, which allows the new P8 PWM to run much more efficiently than its predecessors. This saves energy and lowers the coil temperature without comprimising the performance.
Power Consumption
Maximum Quietness, Minimum Vibration
Even at low speeds the operating sound of the new ARCTIC motor is barely noticeable.
Due to a sinus-magnetizing the new motor only creates about 5 % of the vibration from commutation of a regular DC-motor without filter. Consequently, there is no need for rubber spacers due to the steady and smooth torque of the new motor.
ARCTIC motor
anti-vibration-rubber
without vibration absorption
Noise Level
5 % vibration from
commutation
50 % vibration from
commutation
100 % vibration from
commutation
Extended Life Span
A 10 °C lower motor temperature roughly doubles the life span of a fan.
The new ARCTIC motor has a four times longer service life through its low coil temperature.
Consequently, we have extended the warranty to 10 years.
(New ARCTIC Motor)
(Typical DC-Motor)
Coil Temperature @ 22 °C Ambient Temperature
200 to 1800 RPM
regulated via PWM
Thanks to the 4-pin connector, the RPM can be regulated in a broad spectrum via PWM.
In this way, noise is kept at a minimum while maximum cooling performance is guaranteed when needed.
High Quality Bearing
Thanks to an alloy/lubricant combination developed in Germany, friction within the bearing is reduced and greater efficiency is achieved. As a result, there is less heat development as well as less bearing noise, which means you can enjoy a longer service life from your fan.
Two Way Installation
Push warm air out of the case
Pull cool air into your case
Standard 80 mm fan holes
