Z2Dual Monitor Arm with 4-Port USB Hub
Availability: Out of stock
Adjustment without Removing the Monitor
With the Z2 mounting head, tighten or loosen the swivel per your need in just a few seconds. No need to take the monitor down.
Important note: weight capacity of the mounting table
The maximum capacity of the monitor arm is not necessarily equal to the maximum capacity of the mounting table. Please ensure the monitor arm is mounted on a solid table. Honeycomb-structured or Sandwich-structured tables which are low in weight are not suitable for monitor arms.
Important note: Installation of Z1 & Z2 monitor arm
When installing your ARCTIC Z1 or Z2 monitor arm, in order to strengthen the support of the mounting arm on the pole, a plastic clamp is provided to be installed at the bottom. However, fasten it with too much force might break or damage the plastic clamp (see below).
How to ensure the monitor stays and does not tilt forward naturally?
OPTION 1 (if you got this head):
Tighten the screws on the ball joint to the desired strength, without taking off the monitor.
OPTION 2 (if you got this head):
Tighten the screw under the ball joint.
If you are not satisfied with the result, lose the screw under the ball joint, remove the monitor from the arm and tighten the screw inside the ball joint to the desired strength. Install the monitor back to the monitor arm.
What should I do if my desk is a Honeycomb-structure or Sandwich-structure with hollow pockets?
We recommend to add a board on and under the table to prevent the clamp from rupturing the desk.
Please cut a board using the drawing below or contact us.
Here you find a list of IKEA desks with honey comb recycled paper structure:
* The list is not exhaustive
The product you selected is currently unavailable. Please send us a request and we get back to as soon as possible.